Post Reply 
 
Thread Rating:
  • 0 Votes - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Igo w holes
bluemarky3256 Offline
Senior Member
****

Posts: 373
Likes Given: 8
Likes Received: 67 in 49 posts
Joined: Aug 2013
Reputation: 9
Sex: Male
Location: Leeds , West Yorkshire
Post: #1
Igo w holes
Just got an igo w today put a 2.0 ohm coil and silica wick on it but the draw is really tight compared to its little bro the igo s so how much bigger should I drill the holes and should I drill both or just one.

Cheers
10/10/13 02:06 PM
Find all posts by this user Like Post Quote this message in a reply Return to top
anthropolyte Offline
He of the beautiful hands
******

Posts: 2,482
Likes Given: 215
Likes Received: 852 in 517 posts
Joined: Jun 2013
Reputation: 22
Sex: Undisclosed
Location: Bristol, UK
Post: #2
RE: Igo w holes
It depends on how airy a draw you want. I personally drilled mine out to about 0.7mm (both holes) - gives the equivalent of a 1.4mm air hole, which is pretty airy.

Most people go for 0.5mm per hole, which is a good place to start.
10/10/13 02:08 PM
Find all posts by this user Like Post Quote this message in a reply Return to top
bluemarky3256 Offline
Senior Member
****

Posts: 373
Likes Given: 8
Likes Received: 67 in 49 posts
Joined: Aug 2013
Reputation: 9
Sex: Male
Location: Leeds , West Yorkshire

Thread Starter

Post: #3
RE: Igo w holes
Cheers, I'll start with 0.5 and give that a go then I do like a bit more of an airy draw than it is now I'm getting a right jaw ache vaping on it lol , just need to find my dremmel

Ta
10/10/13 02:24 PM
Find all posts by this user Like Post Quote this message in a reply Return to top
bluemarky3256 Offline
Senior Member
****

Posts: 373
Likes Given: 8
Likes Received: 67 in 49 posts
Joined: Aug 2013
Reputation: 9
Sex: Male
Location: Leeds , West Yorkshire

Thread Starter

Post: #4
RE: Igo w holes
That's done the trick and changed to cotton wool wick wow nice now
10/10/13 02:59 PM
Find all posts by this user Like Post Quote this message in a reply Return to top
Post Reply 




User(s) browsing this thread: 1 Guest(s)